Axis 25734 Manual do Utilizador

81-IN6222R3PRODUCT INSTRUCTIONSMODEL:25734C O M M U N I C A T I O N SforBefore attempting to connect or operate this product,please read these instruc

Remove 24Vac to 12VDC power board located inside of housing, attach 2 “L ” brackets to mounting plate. Connect Pan tilt with hardware provided.• Q

TabConnect Lanyard to trim ring assembly.• Conecte el acollador con el montaje del anillo del ajuste.• Reliez la lanière à l'anneau d'équi

25734Replacement Parts ListPart Number Description1 RPFD7015 Lower Trim Ring2 RC7AT Tinted Replacement CapsuleRC7AC Clear Replacement Capsule3 RPFD703

!!SAFETY PRECAUTIONSIMPORTANT SAFEGUARDS1. Read Instructions - All the safety and operating instructions should be read before the unit is operated.2

Content of BoxHardware Packet25734 Outdoor Housing (Clear)Power 24VACClass 2 Only Total Power: 89 Watts Heater: 50 Watts Blower: 2 WattsCamera Powe

1 Securely mount bracket to wall. Pull wiring through bracket and position grommet as shown. • Con seguridad soporte del montaje a emparedar. Tire

5 Loop the lanyard over the set screw to temporarily hold housing.• Coloque el acollador sobre el tornillo de presión para celebrar temporalmente la

RJ45RJ4524VAC1234CameraCameraHeater/BlowerHeater/BlowerRedOrangeYellowGreenSNC-RZ25/SNC-RZ55018 Watts 25 Watts 52 Watts 1/01234Alarm 1Alar

182685 Mounting PlateMounting HoleMounting HoleMounting HoleAxis 214(52mm) 2"Captive Screw(3) #8 x 3/8” Install the camera to the moun

TabLoosen ScrewAXIS 231-232D18 Loosen the screw to the right of the tab by approximately (5) turns.• Afloje el tornillo a la derecha de la lengüeta

3mm Screw Power BoardConnection Module20 This is what the typical path of illumination will look like with the setting at 30 degrees.• Para quitar a