Axis HP-MIO 2 Manual do Utilizador descarregar pdf (Página 36)

Appendix A: The AXIS HP MIO Rear Panel

36 AXIS HP MIO User’s Manual

HP MIO



Set the rotary switch to position 9 to enter Test Mode. When the

SYSTEM indicator starts to flash, select one of the following

functions:

Caution 5250/Twinax Users: Don’t forget to set the rotary switch to the device

address after exiting Test Mode.

Notes: ❏ To set factory default configuration, a two-step operation is

required in order to avoid accidental activation and loss of

configuration settings. When position 1 is selected, the yellow PC

SHARE indicator begins to flash. To confirm this selection,

switch to position 2 within two seconds.

❏ The Hex Dump modes are useful when analyzing incorrect

printouts, but be careful – they can consume huge amounts of

paper! Refer to the AXIS HP MIO Technical Reference for

details.

❏ The Terminal Configuration Utility provides an easy-to-use

method of customizing the AXIS HP MIO board using a directly

attached IBM 5250/3270 display station. Refer to the AXIS HP

MIO Technical Reference for details.

Position Test Mode Function

0 Reserved

1 Set Factory Defaults – abandon the current conﬁguration

2 Conﬁrm Factory Defaults – see note below

3 ASCII Hex Dump Mode – print the outgoing data stream as hexadecimal

values

4 System Hex Dump Mode – print the incoming data stream as hexadecimal

values

5 Reserved

6 Reserved

7 Terminal Conﬁguration – run the Conﬁguration Utility on an IBM display

station

8 Print Parameter List – print the complete conﬁguration

9 Exit Test Mode – resume normal print operation

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Sem comentários

Axis HP-MIO 2 Manual do Utilizador Página 36