Axis AXIS USB Manual do Utilizador descarregar pdf (Página 12)

2.2.4 Mk3 CTRL connector

This connector provides inputs for use of MPG pendant devices and E-Stop.

Spindle speed encoder for spindle synchronization can also be connected.

GND pin provides ‘Ground’ or common connections.

An E-Stop switch attached to this connector can be configured in software to activate/deactivate E-

Stop.

E-Stop switch hardware for use with this connector can be NC (Normally Closed) or NO (Normally

Open). If NC is used, 'Invert' feature must be enabled in 'settings'. Locking switch is recommended.

CONNECTOR PIN DESCRIPTION:

E-STOP: E-Stop

MD1: Mode switch

MD2: Mode switch

AX1: Axis switch

AX2: Axis switch

EN1A: Encoder for MPG

EN1B: Encoder for MPG

IDX: Index signal for spindle synchronization

+5V: Power supply for encoder

EN2B: Additional encoder

EN2A: Additional encoder

EN3B/AX3: Axis switch for additional axes or encoder

EN3A/AX3: Axis switch for additional axes or encoder

EN4B: Encoder for spindle synchronization

EN4A: Encoder for spindle synchronization

GND: Ground

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 34 35

Sem comentários

Axis AXIS USB Manual do Utilizador Página 12