Axis 35541 Ficha Técnica Página 1

81-IN6221R3PRODUCT INSTRUCTIONSMODEL:Before attempting to connect or operate this product,please read these instructions completely.C O M M U N I C A

Camera specification for 24VAC outdoor housing. No electronics are included with indoor unit.• Especificación de la cámara fotográfica para la cub

Remove power board. Use secrewdriver to release plastic fasteners by applying pressure to sides while pulling out. Construct mounting bracket asse

17Assemble Axis locking plate to quick release plate using (3) #8 bolts, washers and nuts. Connect the combined plates to the bracket

Fasten down the dome with a Phillips screwdriver.• Sujete abajo de la bóveda con un destornillador Phillips.• Attachez en bas du dôme avec un tourne

25733Replacement Parts ListPart Number Description1 RPFD7501 Lower Trim Ring (Long)2a2bRCTFD7 Tinted Replacement CapsuleRCFD7 Clear Replacement Capsul

Clear 25733, 25735 24 VAC 3.7 Amps 89 Watts Accessories: Heater: 50 Watts/Blower: 2 Watt Came

!!SAFETY PRECAUTIONSIMPORTANT SAFEGUARDS1. Read Instructions - All the safety and operating instructions should be read before the unit is operated.2

1 Securely mount bracket to wall. Pull wiring through bracket and position grommet as shown. • Con seguridad soporte del montaje a emparedar. Tire

5 Loop the lanyard over the set screw to temporarily hold housing.• Coloque el acollador sobre el tornillo de presión para celebrar temporalmente la

RJ45BNC24VAC1234CameraCameraHeater/BlowerHeater/BlowerRedOrangeYellowGreenPOWER25 Watts 26 Watts 1/01234Alarm 1Alarm 2Alarm 3CommonBlueVioletG

182685 Mounting PlateMounting HoleMounting HoleMounting HoleAxis 214(52mm) 2"Captive Screw(3) #8 x 3/8” Install the camera to the moun

Attach camera to quick release plate as shown. Use spacers to assemble (4) 3” legs. Secure camera into position.• Una la cámara fotográfica a la

3mm Screw Power BoardConnection Module20 This is what the typical path of illumination will look like with the setting at 30 degrees.• Para quitar a