Axis P1344-E Guia de Instalação descarregar pdf (Página 11)

AXIS P13-E Network Camera Series Installation Guide Page 11

ENGLISH

Connect the cables

1. Optionally insert an SD memory card (not included) into the SDHC (Secure Digital High

Capacity) card slot. A standard or high capacity SD card is required to store images locally in

the camera.

2. Optionally connect external input/output devices. See page 21 for information on the terminal

connector pins. Prepare the cables with gaskets, see Prepare the network cable, on page 8, and

route the cables through the cable holes into the bottom cover and to the camera.

3. Connect the camera to the network using a shielded network cable. Connect the network cable

to the network connector on the bottom. The network cable and the I/O cable between the

bottom cover and the camera are already connected at delivery

4. Check that the indicator LEDs indicate the correct conditions. See the table on page 23 for

further details. Note that the Status LED can be configured to be unlit during normal operation.

Cold Startup Delay Switch

The housing used in this Axis product features Arctic Temperature Control, which is enabled by

setting the Cold Startup Delay switch to I (ON). When enabled, this function controls when the

camera restarts after a power cut, when temperatures are below 0 °C (32 °F); the camera is first

heated to approximately 0 °C (32 °F) before it initializes. This prevents damage to camera models

that include moving parts. Since this camera does not require this function, it is disabled by default.

Cable holes

Network connector (PoE IN)

Alarm output

Cold Startup Delay switch

LED indicator

(enabling not required - see text below)

Network connector (PoE OUT,

connected at delivery)

Bottom cover

I/O cable

Network cables

(connected at delivery)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 129 130

Sem comentários

Axis P1344-E Guia de Instalação Página 11