Axis 670 Manual de Instruções descarregar pdf (Página 21)

Do not operate the system under these condition or damage to the scanner may occur. See

section 3.2. "Input Power" for a more detailed discussion on this.

3.12. Mirror Alignment Mode

The mirror alignment mode shunt is

W5.

It allows the user to loosen the mirtor screws, align the

mirrors, and retighten the mirror screws, without the system going unstable. It does this by

lowering the loop gain of

the

system. When W5 is shorting pins 2 and 3, the system is in the

normal operating mode. When

the

jumper is between pins 1 and 2, the system will center itself

and feel somewhat

"limp"

compared to normal operation. The scanner will not follow any input

signals when in class

mode.

••Caution!! If

the

system is set up for class 0 operation, the scanners will still follow the input

signal, but at a much reduced loop gain. Do not operate the scanner in this mode except to align

the mirtors. Damage to the system could result and void the warranty. Refer to the tuning

procedure in section 6.0 for the mirror alignment procedure.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 67 68

Sem comentários

Axis 670 Manual de Instruções Página 21