Axis AXIS USB Manual de Instruções descarregar pdf (Página 30)

Then click on page “Motor Outputs”. Put green ticks in column “Enabled” on “X

Axis”, “Y Axis”, “Z Axis” and “A Axis” row and “Dir LowActive” according to the

requirements. The other columns have no effect on HyCNC-4P’s operation. The

length unit used by Mach3 can be set by operation the main menu

“Config”->”Select Native Units”. The choose “MM’s” or “Inches” as needed.

Finally, the motor operation characteristics need to be set. Operate the main

menu “Config”->”Motor Tuning and Setup”.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 67 68

Sem comentários

Axis AXIS USB Manual de Instruções Página 30