Axis RightFax 8.5 Manual do Utilizador descarregar pdf (Página 15)

RightFax 8.5

EN/LZT 108 5826/6 R2B Ericsson



November 2002 11

Creating a “Source” Mailbox for Delivering Faxes

You must create a mailbox that the fax server can use to deliver faxes to OneBox

recipients. The telephony server uses the name of this mailbox as the sender’s name on

faxes routed from the fax server to destinations within the telephony server. While this

mailbox can be a subscriber mailbox, we strongly recommend that you use a call

processor mailbox, which does not require a security code for access and which allows

simultaneous logins.

Note If you use a subscriber mailbox as the source mailbox, configure only one

WorkServer for telephony server routing when you set up RightFax.

WorkServers require a logon to the source mailbox to deliver faxes. Subscriber

mailboxes allow only one logon at a time.

OneBox uses the name that you record for this mailbox as the information prompt

subscribers hear when a fax message is received from outside the system.

! To provide a call processor for fax messaging:

1. Create the call processor mailbox and specify a name that identifies the source

of the fax, such as Fax Server. It is not necessary to configure any key actions for

this call processor, because the fax server will be interacting with it over a LAN

connection rather than by telephone. However, to ensure that any caller who

gains access to this mailbox by accident is returned safely to the telephony

server’s current initial call processor, we recommend that you set all key actions

to GoAnsMode.

2. Record a name for this mailbox. This name should be a generic phrase, such as

“… the fax server,” that will follow such system prompts as “This fax was sent on

June 15th at 2:23 PM by …”

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Sem comentários

Axis RightFax 8.5 Manual do Utilizador Página 15