Axis 7100 Guia de Instalação descarregar pdf (Página 215)

100

101

ADT Model 7100 Semi-Automatic Dicing System Operations Manual

Manual Y Offset

P/N 97100-9002-000-14 Ver 06/05

6.4-3

6.4.3 Y-Offset Reference Positions

This feature enables Teaching the reference position (center, lower edge or

upper edge) and the pattern type (middle, kerf up, kerf down, upper bar or

lower bar) of each kerf model separately. Reference position refers to the

part of the kerf model from which the Y coordinate result should be taken.

The Y-coordinate can be based on the following options:

• Lower Edge: The Y coordinate result would be taken from the lower

edge of the kerf.

• Upper Edge: The same as lower edge, only for the upper edge.

• Center: The Y coordinate result is taken from the kerf's center.

To set Y-Offset Reference Position

1 Under the General tab, locate the Y-Offset category.

2 Select a value for Y-Offset Reference Position parameter. The default

value is “Center”. (see Figure 2-5).

6.4.4 Y-Offset on Dress Block

Y-Offset can be performed either on the Workpiece or on the Dress Block.

The Y-Offset location depends on whether or not a cut was already

performed:

• If the previous cut was on the Workpiece, Y-Offset is performed on the

Workpiece.

Figure 6-37: Y-Offset Reference Position

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 423 424

Comentários a estes Manuais

Sem comentários

Axis 7100 Guia de Instalação Página 215

Comentários a estes Manuais

Manuais e produtos relacionados com Servidores Axis 7100