Axis CAMERA RECORDER 1.1 Manual do Utilizador descarregar pdf (Página 26)

AXIS Camera Station Administration

26 AXIS Camera Station User’s Manual

Recordings

All settings that pertain to Recordings; e.g. motion detection, recordings trig-

gered by an incoming signal from an input/output and saving recorded images

are defined under this tab.

Select camera Select any of the available cameras. The maximum number of cameras

available is determined by your license.

Recording Method

Continuous recording Check this if you want the server to continuously save images. This option uses

much more disk space than recording only when motion is detected or when

there is an external alarm.

Record every (seconds) Set the recording frame rate (X frames per second). If 0 is selected, the frame

rate specified in the Target recording frame rate (fps) bar is used.

Record on I/O alarms Check this to start recording when there is an incoming alarm from an I/O. This

could be from a device connected to an I/O, e.g. from a door switch, a smoke

detector, etc.

Some Axis camera's have their own built-in motion detection, which can be

used independently of AXIS Camera Station. Check this option to use the

camera's own motion detection to trigger recordings in AXIS Camera Station -

this will be treated as any other I/O alarm.

When setting up motion detection in the camera itself, there are two ways that

detected motion can cause an alarm in AXIS Camera Station:

• By uploading images to the same FTP directory as specified in AXIS Camera

Station.

• By configuring the camera to also trigger an I/O when motion is detected.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 72 73

Sem comentários

Axis CAMERA RECORDER 1.1 Manual do Utilizador Página 26