Axis BTA 2100D Manual do Operador descarregar pdf (Página 280)

100

101

278

You can use a spit ratio of 100 after injection to vent the injector of any residual

solvent.

Use a very low split ratio after flushing to conserve carrier gas.

The first row of the spreadsheet contains the Initial Split State and Split Ratio for

the 1079 injector. The 1079 will equilibrate to this setting when the method is

activated, and will be restored to this setting when each chromatographic run is

completed.

Rows after the first row of the spreadsheet contain the time-programmed settings

for the 1079 Split Ratio. The Split Valve will be switched to the ratio in each row

at the indicated time.

1177 Injector

If you indicate that a 1177 Injector is installed, an Oven Power switch, a

Temperature setting and a Split Ratio button will appear.

Indicate whether or not you will use the

installed 1177 injector by clicking on

the “On” or “Off” radio buttons.

Set the desired

Temperature.

If the 1177 Injector is connected to a Type 1

EFC, press the “Split Ratio” button to build the

Split Ratio Time Program.

NOTE: You must have already configured the Type 1 EFC in the corresponding

position in the Flow/Pressure Section before you can program the split ratio.

Specifically, to build a 1177 Split Ratio Program, a Front 1177 must have a

corresponding Front Type 1 EFC, a Middle 1177 must have a corresponding

Middle Type 1 EFC, and a Rear 1177 must have a corresponding Rear Type 1

EFC.

Use the Split Ratio spreadsheet to build a split ratio time program to control the

1177 injector / Type 1 EFC combination.

1 2 ... 275 276 277 278 279 280 281 282 283 284 285 ... 596 597

Comentários a estes Manuais

Sem comentários

Axis BTA 2100D Manual do Operador Página 280

Comentários a estes Manuais

Manuais e produtos relacionados com Software Axis BTA 2100D