Axis BTA 2100D Manual do Operador descarregar pdf (Página 315)

100

101

313

Type 4 Injector EFC Flow/Pressure Status:

Item Description

Ready Yes or No.

The Type 4 Injector EFC component is Ready (Yes) if the

setpoints have been achieved and stabilized. The Type 4

Injector EFC component is Not Ready (No) if readiness to

start a run has not been achieved or if, during a run, the EFC

becomes not ready or goes “out of tolerance”. Some reasons

the GC may go Not Ready during a run are: the temperature

program is too aggressive, the oven door is opened, the

coolant runs out, the power line voltage drops, etc.

Fault Yes or No.

Displays if a fault in the Type 4 EFC component has

occurred.

Type 4 Pressure

Setpoint

0.1 to 100 psi

Displays the programmed column head pressure setting in

the active method.

Actual Pressure

0.1 to 100 psi

Displays the actual column head pressure at the 3800 GC.

Column Flow

Displays, in ml/min, the column flow rate calculated from the

column head pressure, column temperature, and column

parameters (carrier gas, column length, and internal

diameter).

This value is not displayed if the column length has not been

set in the 3800 GC column parameters setup.

Total Flow

1 to 1000 ml/min

Displays the programmed total flow rate in the active method.

Linear Velocity

Displays, in cm/sec, the column linear velocity calculated

from the column head pressure, column temperature, and

column parameters (carrier gas, column length, and internal

diameter).

TCD Status:

Item Description

Ready

Yes or No.

The TCD detector is Ready (Yes) if the setpoints have been

achieved and stabilized. The TCD detector is Not Ready (No) if

readiness to start a run has not been achieved or if, during a run,

the TCD detector becomes not ready or goes “out of tolerance”.

Some reasons the GC may go Not Ready during a run are: the

temperature program is too aggressive, the oven door is opened,

the coolant runs out, the power line voltage drops, etc.

Fault

Yes or No.

Displays if a fault in the TCD detector component has occurred.

TCD Electronics

On or Off

Displays the TCD Electronics setting in the active method.

Range 0.05, 0.5, or 5.0

1 2 ... 310 311 312 313 314 315 316 317 318 319 320 ... 596 597

Comentários a estes Manuais

Sem comentários

Axis BTA 2100D Manual do Operador Página 315

Comentários a estes Manuais

Manuais e produtos relacionados com Software Axis BTA 2100D