Axis BTA 2100D Manual do Operador descarregar pdf (Página 407)

100

101

405

Item Description

Detector Channel Indicates the detector channel that is specified by the

remaining fields in the row. Channels are indicated by

the detector module name, bus address, and channel

identifier. The combo box contains entries for all

channels having data handling sections in the active

method. If the desired channel is not visible in the

combo box, make sure that the correct method is active

and that it contains data handling sections for the

desired channel.

Calculation Type Internal Std

External Std

Normalized %

No Calibration

Indicates the calibration method specified for the

detector channel in the active method. To change the

calibration method for a specific channel, first click on

the channel’s row, then click on the “Edit Calibration

Setup” push-button. If the Calculation Type is not

Internal Std or Normalized %, the “Edit Standard

Peak(s)” push-button will be disabled.

Unid Peak Factor 0 to 1,000,000

Sets a calibration factor for unidentified peaks.

Multiplier 0.000001 to 1.000,000

Sets a value for the multiplier. Results for the sample

are multiplied by this value.

Divisor 0.000001 to 1,000,000

Sets a value for the divisor. Results for the sample are

divided by this value.

Standard Peak 1 40 character standard peak name from peak table

Indicates the name of the first Internal Standard Peak.

The Amount Standard 1 will be applied to the Internal

Standard Peak having the same name. To change the

standard peak name for a specific channel, first click on

the channel’s row, then click on the “Edit Standard

Peak(s) push-button.

Amount Standard 1 0.000001 to 1,000,000

Sets the amount of the first internal standard. Used to

calibrate results for Internal Standard and Normalized

Percent calculations.

Standard Peak 2-8 40 character standard peak name from peak table

Indicates names of the multiple internal standard peaks

present in the specific channel’s peak table. . To change

the standard peak names for a specific channel first

click on the channel’s row, then click on the “Edit

Standard Peak(s) push-button. If the peak table does

not contain multiple internal standards, these fields will

be disabled.

1 2 ... 402 403 404 405 406 407 408 409 410 411 412 ... 596 597

Comentários a estes Manuais

Sem comentários

Axis BTA 2100D Manual do Operador Página 407

Comentários a estes Manuais

Manuais e produtos relacionados com Software Axis BTA 2100D