Axis BTA 2100D Manual do Operador descarregar pdf (Página 422)

100

101

420

Specifying Per-Sample Data Handling Parameters

Most Data Handling parameters are specified in the Method used during the

injection. Some parameters may vary on a per-sample basis, and are therefore

specified when you perform the injection. The following Data Handling

parameters can be specified on a per-sample basis:

 Unidentified Peak Factor

 Multiplier

 Divisor

 Amount Standard when one Internal Standard is being used

Refer to the Data Handling and Reports Manual for a brief description of these

parameters. Refer to the Regulatory Compliance Manual for a complete

description of how these parameters are used to calculate results.

Not only can you specify these parameters on a per-sample basis, but you can

specify them on a per-detector channel basis when doing standard GC data

handling. This is useful if, for example, you have different detectors installed on

your GC. In addition, if you are using multiple internal standards, you can also

specify their amounts on a per sample and per detector channel basis. Note that

when doing MS data handling, the analogous specifications are made in the data

handling method.

To access these extended Data Handling parameters, click on the button in the

Multi-Channel Multi-Standard column in the 8200 SampleList. You will be

prompted for the Method that will be used when this SampleList is run. Then

Data Handling Channels dialog box is displayed. When you select the detector

channel in the Data Handling Channels dialog box, the calculation type, internal

standard peaks and amounts are read from the Method that you just selected.

The values entered for internal standard peaks and amounts will be entered into

the peak table of this method.

Select specific detector channels here (up to 4).

An amount may be entered for each internal standard peak in the Method.

Use these buttons to edit the corresponding sections of the active Method.

1 2 ... 417 418 419 420 421 422 423 424 425 426 427 ... 596 597

Comentários a estes Manuais

Sem comentários

Axis BTA 2100D Manual do Operador Página 422

Comentários a estes Manuais

Manuais e produtos relacionados com Software Axis BTA 2100D