Axis BTA 2100D Manual do Operador descarregar pdf (Página 450)

100

101

448

Item Description

Weighted Regression None, 1/n, 1/nX, 1/X2, or 1/nX2

Sets the weighted regression scheme to be used in

determining calibration coefficients.

Replicate Treatment Keep Replicates Separate or Average Calibration

Replicates

Determines whether new replicates are kept separate

or whether they are averaged into an existing historical

value. When keeping replicates separate, there is a

limit of 10 replicates that can be stored. However, you

can indefinitely continue to average new replicates into

the historically maintained value.

Averaging Weight 0-100%

Sets the weight given to new calibration replicates

when averaging into the historical value.

Replicate Tolerance Always add new replicates, Never add new replicates,

Add replicates when within this tolerance (%)

Determines whether a new replicate should be added

to the calibration curve or whether it should be

ignored. Always add new replicates does no

verification of replicates -- they are always added.

Never add new replicates does not add the replicate

and is seldom used. Add replicates when within this

tolerance (%) only adds a replicate to the calibration

curve if within the tolerance specified. This tolerance is

applied the same way as is the Deviation Tolerance for

a Verification run.

Replicate Tolerance % 0 to 500%

Sets the replicate tolerance value.

Replicate Tolerance Out-

of-Tolerance Action

No Action, Increment Error Count, Terminate Sample

List, Halt Automation

Sets which action is taken when a replicate is of

tolerance. Either does nothing (No Action), adds 1 to

the error count (Increment Error Count), stops the run

and goes to the next SampleList (Terminate Sample

List), or halts automation (Halt Automation) each time

a replicate is out of tolerance.

Calibration Range

Tolerance %

0 to 500%

Sets the calibration range tolerance percentage for

which peaks outside the calibration range plus the

tolerance generate calibration range errors. Zero is

always used for the low end of the calibration range

check, even if the valid calibration range does not

extend to the y axis.

Calibration Range Out-of-

Tolerance Action

No Action, Increment Error Count, Terminate Sample

List, Halt Automation

Sets which action is taken when a replicate is of

calibration range. Either does nothing (No Action),

adds 1 to the error count (Increment Error Count),

stops the run and goes to the next SampleList

(Terminate Sample List), or halts automation (Halt

Automation) each time a replicate is out of calibration

range.

1 2 ... 445 446 447 448 449 450 451 452 453 454 455 ... 596 597

Comentários a estes Manuais

Sem comentários

Axis BTA 2100D Manual do Operador Página 450

Comentários a estes Manuais

Manuais e produtos relacionados com Software Axis BTA 2100D