Axis BTA 2100D Manual do Operador descarregar pdf (Página 289)

100

101

287

Indicate whether or not you will use the installed FID Detector by clicking on the

“On” or “Off” radio buttons.

If you indicate that an FID Detector is to be turned on and heated, select the

desired Temperature setting.

Time-program the detector range and autozero in the spreadsheet.

Select the desired FID Time Constant by clicking on the “Slow” or “Fast” radio

buttons.

Select the desired gas flow rates for the detector EFC.

The first row of the spreadsheet contains the Initial Range and Autozero for the

FID Detector. The FID will switch to this setting when the method is activated,

and will be restored to this setting when each chromatographic run is completed.

Rows after the first row of the spreadsheet contain the time-programmed settings

for the Range and Autozero. They will be switched to the value in each row at the

indicated time.

Methanizer

The Methanizer is programmed from the Detector window. Note that the Front

Methanizer is programmed from the Front Detector tab, the Middle Methanizer

from the Middle Detector tab, and the Rear Methanizer from the Rear Detector

tab.

1 2 ... 284 285 286 287 288 289 290 291 292 293 294 ... 596 597

Comentários a estes Manuais

Sem comentários

Axis BTA 2100D Manual do Operador Página 289

Comentários a estes Manuais

Manuais e produtos relacionados com Software Axis BTA 2100D