Axis BTA 2100D Manual do Operador descarregar pdf (Página 319)

100

101

317

ECD Status:

Item Description

Ready Yes or No.

The ECD detector is Ready (Yes) if the setpoints have been

achieved and stabilized. The ECD detector is Not Ready (No) if

readiness to start a run has not been achieved or if, during a run,

the ECD detector becomes not ready or goes “out of tolerance”.

Some reasons the GC may go Not Ready during a run are: the

temperature program is too aggressive, the oven door is opened,

the coolant runs out, the power line voltage drops, etc.

Fault Yes or No.

Displays if a fault in the ECD detector component has occurred.

ECD

Electronics

On or Off

Displays the ECD Electronics setting in the active method.

Range 1 or 10

Displays the ECD Range initial condition setting or the time-

programmed setting in the active method.

Time Const Fast (50 msec) or Slow (200 msec)

Displays the electrometer time constant setting from the ECD

Adjustments in the active method.

Detector

Signal

Displays, in mV, the actual ECD detector signal at the 3800 GC.

Bunch Size Displays the data acquisition bunch size.

Freq Displays the data acquisition bunch rate, in Hz.

TSD Status:

Item Description

Ready Yes or No.

The TSD detector is Ready (Yes) if the setpoints have been

achieved and stabilized. The TSD detector is Not Ready

(No) if readiness to start a run has not been achieved or if,

during a run, the TSD detector becomes not ready or goes

“out of tolerance”. Some reasons the GC may go Not Ready

during a run are: the temperature program is too

aggressive, the oven door is opened, the coolant runs out,

the power line voltage drops, etc.

Fault Yes or No.

Displays if a fault in the TSD detector component has

occurred.

1 2 ... 314 315 316 317 318 319 320 321 322 323 324 ... 596 597

Comentários a estes Manuais

Sem comentários

Axis BTA 2100D Manual do Operador Página 319

Comentários a estes Manuais

Manuais e produtos relacionados com Software Axis BTA 2100D