Axis BTA 2100D Manual do Operador descarregar pdf (Página 375)

100

101

373

Item Description

needle guide, so this height will give you

optimum penetration depth.).

Calibrate Injector Position, Start

Calibration

Press the Start Calibration. The CP-8400/8410

will rotate the tower so that it is over the Injector

position and lower the syringe sled so that it is

over the injector. If the needle guide descends

so that it is either resting on the inject switch or

below the needle cone on the inject switch, use

the Syringe Up button and move the sled up

until the needle guide is just above the injector

cone.

Calibrate Injector Position, Save

Calibration

Press the Save Calibration softkey when the

Injector calibration is complete.

Calibrate Injector Position, Tower

Counterclockwise

Using the Tower Counterclockwise button

rotates the tower counterclockwise 10 steps.

Position the tower directly over the injector

Inject Switch Locator cone.

Calibrate Injector Position, Tower

Clockwise

Using the Tower Clockwise button rotates the

tower clockwise 1 step. Position the tower

directly over the injector Inject Switch Locator

cone.

Calibrate Injector Position,

Syringe Up

Using the Syringe Up button adjust the height

of the needle guide such that the sled is just

resting on or very slightly depressing the

Injector Switch and is covering the locator cone.

Calibrate Injector Position,

Syringe Down

Using the Syringe Down button adjust the

height of the needle guide such that the sled is

just resting on or very slightly depressing the

Injector Switch and is covering the locator cone.

Change Syringe, Start Syringe

Change

Selecting Start Syringe Change will cause the

tower to rotate such that the user will have easy

access to the syringe for routine service and

syringe removal and replacement. The buzzer

will sound before any tower movement occurs.

Press the Finish Syringe Change softkey upon

completion of the syringe maintenance.

Change Syringe, Finish Syringe

Change

Selecting Finish Syringe Change will cause the

tower to return to its previous position and

state. The buzzer will sound prior to movement

as designated by the “Buzzer at start of cycle”

setting.

Change Syringe, Clear Plunger

Counter

Selecting this softkey causes the Plunger

stroke count to be reset to 0.

Use Mouse Buttons to adjust

positions of Tower, Syringe,

and/or Carrousel

Checking this box, changes the Calibrate

AutoSampler Dialog Box for the positions to be

adjusted with the mouse.

Close Closes the dialog box.

1 2 ... 370 371 372 373 374 375 376 377 378 379 380 ... 596 597

Comentários a estes Manuais

Sem comentários

Axis BTA 2100D Manual do Operador Página 375

Comentários a estes Manuais

Manuais e produtos relacionados com Software Axis BTA 2100D