Axis BTA 2100D Manual do Operador descarregar pdf (Página 288)

100

101

286

Detector Window

The Detector window contains up to three Detector Programs (Front, Middle,

Rear). Use the Detector Programs to specify the operating temperatures, gas

flow rates and parameters of the detectors.

Use the tabs to select which Detector Program you wish to edit.

Select the type of Detector (FID, TSD, TCD, ECD, or PFPD) at each position, or

select “None” if no Detector is installed at that position.

Detector EFC modules

The detector Electronic Flow Control modules (EFC), if installed on your 3800

GC, are detector-specific and can be programmed from the Detector window.

Select the type of Detector EFC at each position, or select “None” if no Detector

EFC is installed at that position. Use the detector EFC program in each detector

window (Front, Middle, Rear) to specify the gas flow rates for each module.

Note that selecting the make-up gas and the auto-calibration of the module can

be performed from the Detector EFC Setup and configuration screens on the

3800 GC.

FID Detector

If you indicate that an FID Detector is installed, an Oven Power switch, an

Electronics switch, a Temperature setting and a Time Constant setting will

appear.

1 2 ... 283 284 285 286 287 288 289 290 291 292 293 ... 596 597

Comentários a estes Manuais

Sem comentários

Axis BTA 2100D Manual do Operador Página 288

Comentários a estes Manuais

Manuais e produtos relacionados com Software Axis BTA 2100D